Skip to main content

SRAM Technical Service FAQ
SRAM
SRAM eTap 11-speed System
Programming

Articles in this section

Is RED eTap software or firmware open source? Can I get into the code and tweak it to make it work with 10-speed or change the shift speed at different points in the rear derailleur’s sweep?
Can I set up the SRAM RED eTap 2x11 system to do sequential shifting?
Can I customize the shifter paddle or blip operation? E.g. have the left paddle shift up or connect two blips to one shifter and have each blip shift in a different direction?
Will the blips only perform the same shifting operation as the shifter they are connected to for eTap 2x11?
Can I hold down the eTap 2x11 shift lever to do a rear multi-shift?
Can I program the shift speed?
Can you program in automatic rear compensation shifts when making front chainring selections? i.e. shifting to the small ring and simultaneously shifting into a smaller rear cog?
Will SRAM make periodic eTap 2x11 firmware updates?
Does the eTap 2x11 front derailleur know where in the pedal stroke I am and time the shift accordingly for optimal shifting?
Does SRAM make a head unit that is compatible with SRAM RED eTap?

See more

Will SRAM make periodic eTap 2x11 firmware updates?

December 03, 2019 16:56
Updated

There are no planned regular updates.

Was this article helpful?

192 out of 397 found this helpful

Related articles

Can the SRAM RED eTap 2x11 components communicate with my iOS or Android device?
Can I set up the SRAM RED eTap 2x11 system to do sequential shifting?
Do RED or Force eTap AXS™ have smartphone connectivity? Related: Do I need a USB dongle for potential firmware updates?
Can I update firmware on my AXS components through AXS Web?
How do I know when to charge the eTap® 2x11 derailleur or replace the shifter batteries?

Comments

0 comments

Article is closed for comments.

SRAM Technical Service FAQ

Deutsch Français