No, but you can make a front shift and then keep holding one of the buttons after releasing the other to make the rear multi-shift happen directly after. Or, standard individual shifts can be made immediately following a front shift. This takes a fraction of a second to execute.
Articles in this section
- How do I comfortably shift gears while I am in the drops (“sprint shifts”)?
- Is SRAM RED eTap waterproof?
- Is there a crash mode for eTap 2x11 derailleurs?
- Can SRAM RED eTap 2x11 components withstand a rapid temperature change from cold to hot, and vice versa?
- Is RED eTap software or firmware open source?
- Can I program the shift speed?
- Will SRAM make periodic RED eTap 2x11 firmware updates?
- Are there SRAM eTap remote shifters available?
- How are eTap Blips or eTap Clics interconnected on a TT or Tri setup that does not use drop bar shifters on an 11-speed system?
- How many wired eTap Blips can be plugged into a BlipBox?