Follow the below steps to customize the controller shift settings of your eTap AXS, Eagle AXS, and Reverb AXS systems using the AXS Mobile App.
BEFORE YOU START
CUSTOMIZING SRAM AXS CONTROLLER SHIFT SETTINGS
1) Open the AXS Mobile App. Ensure that Bluetooth is enabled and that your phone is connected to a cellular or Wi-Fi network.
2) Lightly shake your bike or press and release the component’s AXS button to wake them from sleep mode. AXS buttons can be found next to the AXS logo on any AXS component.
NOTICE: The button action required to wake an AXS component is a single Press-and-Release. Do NOT Press-and-Hold the AXS button to wake components. If a component no longer shifts or actuates after pressing the AXS button, complete the AXS System Pairing Process to re-establish function.
3) Select [Connect]. Allow 5-10 seconds for the app to connect.
Tech Tip: There can only be one primary component per bike system and that component is the AXS rear derailleur. The one exception is that a Reverb AXS seatpost should be the primary component of a system when an AXS rear derailleur is not present. For pairing instructions, see our article: How do I pair my AXS components together?
4) Select [Configure Controls]
5.a) Select [SWAP] to reverse controller shift logic.
5.b) Or select any individual action and select its function manually.
5.c) If you are using eTap Blips or Clics scroll down to configure their actions. Each AXS control must have an assigned function. The app will reject the change if what you’re attempting is not possible.
NOTICE: If after changing your drivetrain settings, a component no longer shifts or actuates, the wireless link between components may have been inadvertently disconnected. If you are experiencing this, please complete the AXS System Pairing Process to re-establish function.
Related article: