Troubleshooting

Level | Guide | G2 | Code

• My SRAM MTB DOT brake lever won't actuate. Why is this happening and what can I do about it?
SRAM DOT brakes use a compression fitting at the hose and lever assembly. During installation, it's crucial to torque the compression nut to 8Nm. When this step is missed, fluid cannot pass from th... See more
• My new SRAM brakes don´t have the braking power I expected. What should I do about it?
Fresh out of the box, your new brakes won’t feel like they have any power until you go through the bed-in process. Bed in your new brakes before your first ride to ensure power, consistency, and qu... See more
• How do I fix SRAM brake noise after changing pad compounds?
We advise you to use new rotors when changing to a new pad compound material. All disc brake pad compounds embed a thin layer of pad material into the rotor during brake bed-in and use. Introducing... See more
• How do I fix stuck/sticky pistons in my SRAM DOT brake caliper?
You can fix stuck or sticky caliper pistons by using the SRAM pad advancement procedure. Over time, dirt and grime can keep pistons from moving freely. This can result in pads not advancing far eno... See more
• My SRAM MTB DOT brakes have a contact point too close to the bar what can I do about it?
The Pad Advance Procedure should solve your issue. Contact point means the point in the lever's throw at which the brake begins to engage. If your contact point is too close to the bar and your bra... See more